![]() ![]() Thus, we went to the folder where the files needed to create the Windows PE image are stored. cd c: \ program files \ windows aik \ tools \ petools \.After creating the folder, open a command line with administrator rights and run the following commands and actions for execution: The main thing is not to forget to correct your addresses with those presented below. Unfortunately, I don’t remember if there were such problems, so I advise you to postpone the creation of this folder until the command to copy the Windows PE assembly files. You can create any other folder anywhere else, it doesn't really matter.Ī message was left in the comments that if you immediately create the build folder of the Windows PE image, then there may be problems when copying the build files. We need to create a Windows PE build folder: the folder “ C: \ Windows PE ". If you have not changed anything, then by default it is installed in the folder " C: Program Files \ Windows AIK ", and if this is not the case for you, then adjust the subsequent commands accordingly. To begin with, we naturally need to install the package. We will now walk through the creation of such bootable media with Windows PE along with the ImageX utility, which allows you to capture and deploy images. Therefore, as promised, we will try to create this very bootable Windows PE.Īs I said, Windows PE is included with Windows package AIK. But we have not covered the process of creating installation media with Windows PE. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |